Fieldmann FZP 4001-B Spécifications télécharger pdf (Page 24)

FZP 4001-B

24EN

Motor operation | Cutting

Engine shutdown

Release the throttle lever and leave the engine running at idle speed for several minutes.

Set the switch to „0“ position (STOP). (ﬁg. 20).

Switch (1) (ﬁg. 20).

10. CUTTING

CAUTION! Please read the „Safe operation“ chapter before you continue. We recommend

that you gain some experience by cutting smaller chunks. In this way, you will become

familiar with the saw.

Always observe safety instructions. The chainsaw is designed to cut wood only. Cutting other

materials is inadmissible. Vibrations and kickback vary with different materials. Do not use

the saw as a lever to lift, move or destroy objects. Do not place the saw on ﬁxed stands. It

is forbidden to attach parts or ﬁxtures to the saw other than those speciﬁed in the technical

documentation.

You don‘t need to press the saw into the cut. When the engine is running at full throttle, apply

just a slight pressure on the saw.

If the chain gets caught inside the cut, don‘t try to pull to release but use a wedge or a lever to

expand the cut instead.

Kickback protection (ﬁg. 21)

This saw incorporates a chain brake which immediately stops the chain should a kickback

occur if it works correctly. The chain brake function should be checked before each saw use.

Run the saw at full throttle for 1 - 2 seconds and then lower the front guard. The chain must

stop immediately even at full engine speed. If the chain stops slowly or doesn‘t stop at all,

please replace the brake jaws and the clutch drum before further use.

It is extremely important that the chain brake function and chain sharpening status should be

checked before each use in order to keep necessary safety level of the saw in case of a

kickback. Overriding safety devices, incorrect maintenance or using inappropriate bar or

chain may lead to serious injuries in case of a kickback.

Tree felling (ﬁg. 22)

Please determine the tree falling direction considering wind direction, tree inclination and

location of branches as well as all other factors before you start the work.

The tree surrounding area must be open, free of obstacles and allow your stable position to

be taken. The escape route must be passable.

Please make a wedge notch down to a third of the trunk diameter on the side where the tree is

supposed do fall.

On the opposite side, please make a separation cut above the wedge notch level.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 137 138

Pas de commentaire

Fieldmann FZP 4001-B Spécifications Page 24